This page is a visual representation of the installation process that our customers will go through while installing their new DIY Kitchen. Visual Installation Process #1 Empty Room Check plumbing Getting Started Placing Cabinets Placing Cabinets Finished Assembly Finished Assembly Finishing Touches Finishing Touches Finishing Touches Finished Finished         Visual Installation Process #2     Tools Needed Starting Assembly of Cabinets Find Lowest Point of The Room Lowest Point of The Room Measure Up 871mm From The Lowest Point In The Room, And Mark A Line Check The Plumbing Putting The First Cabinets In Line With 871mm Line, Start At Corner Continue Putting Cabinets Together, Ensuring They Are Level Back To Front, Side To Side Blind Corner, Each Cabinet 630mm From The Wall Corner Cabinet, With 180 Hinges Use The Feet To Adjust The Level Scribe The Panels To suite The Floor Cut Along The Scribe Line With A Jigsaw Scribe Panels To Fit To The Wall Mark Out The Bench Top To Fit Around Wall, Cut With Jigsaw Side The Bench Top Into Place Mark Out Hot Plate And Cut Out With A Jigsaw Mark Out Sink And Cut Out With A Jigsaw Use Bench Connectors, 10mm Spanner And PVA Glue To Join Bench Tops Together Progression Progression Progression Marking Out Handles Measuring Out Handles Mark Out Position Of Handle With a Pencil Drill Holes For Handles Screw The Handles On The High Gloss Doors Come With Protective Wrapping, Take This Off   Clip On Kick Boards Finished!!